Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 114 / 296

6-16 Netra CT Server Service Manual • February 2007
Caution – If you are installing a Netra CP2500 boad in a Netra CT 810 server, do
not install the board in slots 6 and 7.
3. Install the rear transition module first, using the instructions in Section 6.2, “Rear
Transition Modules” on page 6-24 .
After you’ve completed the rear transition module removal and installation
instructions, continue with the next step.
4. Remove the slot filler panel, if necessary.
The slot filler panel is secured to the board cage using two screws, one at the top of
the filler panel, the other at the bottom. Store the slot filler panel in a safe place; you
might use it again if you need to remove a board for an extended period of time.
5. Obtain the replacement board from the shipping kit.
6. If you are installing a new alarm card, remove the blue protective film from the
front of the alarm card.
Caution – You must remove the blue protective film from the front of the alarm
card before installing it into the server. Failure to do so might keep the metal
springfingers on the side of the alarm card from making contact with the metal
panels on the server.
7. Perform any necessary board-specific hardware procedures.
a. If you removed a PMC from a satellite CPU or I/O board, install the PMC into
the replacement satellite CPU or I/O board at this time.
Refer to the documentation that you received with your satellite CPU or I/O
board for more information.
b. If you want to reconfigure a Netra CP2500 board from another server or slot
where the board was used as a cPSB, change the SW3301 dip switch settings to
reconfigure the board as a cPCI satellite board.
FIGURE 6-5
shows the dip switch settings required for the Netra CP2500 board to
be used as a cPCI board.
8. Verify that the ejection levers on the board are unlocked.
You cannot install the board properly if the ejection levers are locked.
9. Keeping the board vertical, slide the board into the slot between the two guides.
The cuts in the handle of the board must align with the square cutouts in the slot.
When the board is completely seated in the board cage, the two ejection levers flip
inward, and the notches in the ejection levers fit smoothly in the rectangular cutouts
in the bottom and top plates.