Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 111 / 296

Chapter 6 Removing and Replacing Hot-Swappable Boards 6-13
10. Unlock the ejection levers.
Caution – Only unlock the ejection levers at this point; do not unseat the board
until the LEDs on the system status panel are in the proper state.
The method you use to unlock the ejection levers varies depending on the model of
the ejection lever used on the board; for example, one model uses red tabs at the top
and bottom to unlock the board (
FIGURE 6-7
). Refer to the documentation that came
with the board for instructions on unlocking the board.
FIGURE 6-7
Unlocking the Ejection Levers
11. Locate the LEDs on the system status panel for the board that you want to remove.
The system status panel on each server has LEDs that show the status of the board
installed in each set of the slots in that server.
FIGURE 6-8
shows the LEDs on the
Netra CT 810 server and
FIGURE 6-9
shows the LEDs on the Netra CT 410 server.
FIGURE 6-8
LEDs on the System Status Panel (Netra CT 810 Server)