Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 187 / 296

Chapter 9 Removing and Replacing the Servers 9-9
9.2 Installing a Server
Refer to the Netra CT Server Product Overview for combinations of Netra CT 410
server and Netra CT 810 server supported within a chassis.
Caution – Verify that all RTMs are completely unseated before proceeding with
these procedures. If you attempt to insert a server without unseating the RTMs, you
might damage the connector pins on the midplane when you insert the server.
1. Remove the blank filler panel, if necessary.
Store the slot filler panel in a safe place; you might need to use it again if you need
to remove a server for an extended period of time.
2. With your left hand, grasp the server handle.
3. With your right hand, grasp the purple server bar at the top of the server and
insert the server into the chassis using the flat server handle and the server bar.
FIGURE 9-4
shows how to insert a Netra CT 810 server into the chassis, and
FIGURE 9-5
shows how to insert a Netra CT 410 server into the chassis.
4. Push the purple server bar at the top of the server down and gently push the
server the remaining distance into the chassis.
5. Using a No. 2 Phillips screwdriver, tighten the captive screws that secure the
server to the chassis.
Tighten the screws on the server to a torque of 0.45 - 0.68 N.m (4 - 6 in.-lb).
■
If you are installing a Netra CT 810 server, tighten the four black captives screws
at the top of the server and the three black captive screws at the bottom of the
server (
FIGURE 9-2
).
■
If you are installing a Netra CT 410 server, tighten the two black captive screws at
the top of the server and the two black captive screws at the bottom of the server
(
FIGURE 9-3
).
6. Reseat all the rear transition modules into the replacement server.