Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 182 / 296

9-4 Netra CT Server Service Manual • February 2007
■
If you are removing a functioning Netra CT 810 server or Netra CT 410 server to
access a component behind the server, you do not have to unplug all the cables
and remove all the components from the server. Skip to Step 8 .
5. Label all the cables connected to the front of the server.
Note that you do not have to unplug any cables connected to boards installed in the
rear of the chassis.
6. Unplug all cables from the boards installed in the front of the server.
7. Remove all the components from the server.
Later, you will reinstall them in the replacement server.
Remove the components using the instructions in the following sections:
■
Section 7.2.1, “Removing a DVD or DAT Drive” on page 7-10 (Netra CT 810
server)
■
Section 8.1.1, “Removing the System Status Panel” on page 8-2
■
Section 8.2.1, “Removing the System Controller Board” on page 8-6
■
Section 8.5.1, “Removing a Fan Tray” on page 8-17
■
Section 6.1.2.1, “Removing a Board” on page 6-9
■
Section 10.1.1, “Removing a Cold-Swappable Hard Drive” on page 10-2
■
Section 10.2.1, “Removing a Cold-Swappable Power Supply Unit” on page 10-5
8. Using a No. 2 Phillips screwdriver, loosen the captive screws that secure the server
to the chassis.
■
If you are removing a Netra CT 810 server, loosen the four black captives screws
at the top of the server and the three black captive screws at the bottom of the
server (
FIGURE 9-2
).
■
If you are removing a Netra CT 410 server, loosen the two black captive screws at
the top of the server and the two black captive screws at the bottom of the server
(
FIGURE 9-3
).