Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 107 / 296

Chapter 6 Removing and Replacing Hot-Swappable Boards 6-9
6.1.1.3 Rules and Restrictions for Hot-Swapping the Alarm Card
Following are the rules and restrictions you must understand before hot-swapping
an alarm card:
1. You must have the host CPU board and the system controller board installed in
the Netra CT server before you can hot-swap an alarm card.
2. You cannot hot-swap any other component in a Netra CT server unless the alarm
card is installed and fully booted.
6.1.2 Removing and Replacing Boards
The individual slots in your server are set to full hot-swap by default. You can
change the slots to basic hot-swap manually. See Chapter 5 for more information.
■
If you are removing and replacing a board in the server, first go to Section 6.1.2.1,
“Removing a Board” on page 6-9 , then go to Section 6.1.2.2, “Inserting a Board”
on page 6-15 .
■
If you are installing a board in the server, go to Section 6.1.2.2, “Inserting a Board”
on page 6-15 .
6.1.2.1 Removing a Board
Note –
Do not proceed with the following instructions until you review the
information in Section 6.1.1, “Rules and Restrictions for Hot-Swapping Boards” on
page 6-5 . Failure to do so might result in an inadvertent system reboot or incorrect
configuration.
1. Locate the board that you want to remove from the server.
FIGURE 6-1
shows the locations of the boards in a Netra CT 810 server.
FIGURE 6-2
shows the locations of the boards in a Netra CT 410 server.
2. Log in to the Netra CT server.
See Section 5.2.1, “Logging In to the Netra CT Server” on page 5-5 , then go to the
next step.