Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 163 / 296

Chapter 8 Removing and Replacing Hot-Swappable Subassemblies 8-9
FIGURE 8-9
Inserting a System Controller Board
4. Slide the board into the slot (
FIGURE 8-9
).
5. Flip the ejection lever up as you slide the board into the slot to completely seat it
in the board cage.
The notch on the ejection lever should fit into the cutout.
Caution –
Do not force any board into a slot; this can cause damage to the board
and system. The board should insert and seat smoothly. If it binds, remove the board
and inspect the board cage slot for any obvious obstructions.
When the board is completely seated, a brief flash of light displays behind the board.
■
If the light flashes on and off, then remains off, the board is seated and
functioning properly.
■
If the light flashes on and remains on, then the board is either not seated properly
or is faulty. Try reseating the board. If the light continues to stay on after repeated
attempts, then the board is faulty.
6. Replace the system status panel, as described in Section 8.1.2, “Replacing the
System Status Panel” on page 8-4 .
HDD0
HOT
SWA
P
COM 1
E
NET 1
E
NET 2
ALARM
COM 2
HDD0
ALAR
M/US
ER
HOTSWA
P
ET
HERN
ET
RE
ADY
CO
M
RE
SET
ABO
RT
mic rosy
stem
s
1
2