Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 108 / 296

6-10 Netra CT Server Service Manual • February 2007
3. Perform any board-specific software commands.
■
If you are removing an alarm card from the server, record the settings that you
have for the current alarm card so that you can use them on the replacement
alarm card. Refer to the
Netra CT Server System Administration Manual for
instructions on displaying the settings.
■
For any other board, there could be board-specific software commands that you
must perform before removing the hot-swappable board. Refer to the
documentation that you received with the board for any board-specific
procedures before proceeding.
4. Determine the hot-swap state for the slot that holds the board you want to
remove.
To determine the current hot-swap state for the slots in your server, as superuser,
enter:
The output is similar to the following (note that the following output is for a Netra
CT 810 server; the output is similar for the Netra CT 410 server):
# prtconf -v -P
cphsc, instance #0
System properties:
name=’instance’ type=int items=1
value=00000000
name=’default-hotswap-mode’ type=string items=1
value=’full’
Driver properties:
name=’AL-8-autoconfig’ type=string items=1 dev=none
value=’enabled’
name=’IO-7-autoconfig’ type=string items=1 dev=none
value=’enabled’
name=’IO-6-autoconfig’ type=string items=1 dev=none
value=’enabled’
name=’IO-5-autoconfig’ type=string items=1 dev=none
value=’enabled’
name=’IO-4-autoconfig’ type=string items=1 dev=none
value=’enabled’
name=’IO-3-autoconfig’ type=string items=1 dev=none
value=’enabled’
name=’IO-2-autoconfig’ type=string items=1 dev=none
value=’enabled’
name=’CPU-autoconfig’ type=string items=1 dev=none
value=’enabled’
name=’hotswap-mode’ type=string items=1 dev=none
value=’full’