Ross Synergy 1, Руководство по обслуживанию

Страница: 81 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16-S1) Option Boards • 4–11
4. To remove an existing Squeeze & Tease 3D/WARP Board :
• Locate the Squeeze & Tease 3D/WARP Board .
• Loosen and remove the mounting screws from the holes and set them aside in a safe
place.
• While applying upward pressure, slowly rock each connector out of its socket,
being careful to avoid flexing the board too much — so as not to bend the pins.
• Set the board aside on a clean, flat, static free surface.
5. Unpack the Squeeze & Tease 3D/WARP kit, consisting of one Squeeze & Tease 3D /
WARP Board (4000A-148).
6. If protective plastic shrouds are installed over the target connectors on the Frame
Processor Board , remove and store them.
7. Install the Squeeze & Tease 3D / WARP Board as follows:
• Locate the three sockets labeled “ Squeeze & Tease Conn ” on the Synergy 1
Frame Board , near the middle, front of the board. The sockets are labeled J20 ,
J22 , and J23 .
~ The three Synergy 1 Frame Board sockets will mate with the three headers on
the S&T 3D / WARP board.
~ The Squeeze & Tease 3D / WARP Board headers are labeled J1 , J2 , and J3 .
Use the figure “ Squeeze & Tease 3D/WARP Board ” on page 4–9 for
reference.
~ The header-to-socket mating pattern is J1
→
J20 , J2
→
J23 , and J3
→
J22 .
• Carefully align the Squeeze & Tease 3D/WARP Board over the connectors.
• Ensure that the Squeeze & Tease 3D/WARP major components of the board are
facing up. You will have the correct board orientation when you can read the Ross
Video logo and Squeeze & Tease 3D / WARP silk screening identification on the top
of the board.
• Use your fingers to “feel” for the proper header-to-socket alignment.
• While applying downward pressure, slowly rock the module until the module is
fully seated. Avoid flexing the board — so as not to bend the pins.
Caution When handling the Squeeze & Tease 3D / WARP Board , DO NOT
touch the heatsink, located in the middle of the board. Handle the
board by the edges. Handling of the heatsink may cause serious
damage to the heatsink and to the board.
Note that the heatsink will become HOT when the device is in
operation and should be avoided.
Note
The
J3
header on the Squeeze & Tease 3D/WARP Board is a 50-pin
connector. It mates with a 36-pin socket (
J22
) on the Synergy 1/100
Frame Board . Once the board is fully seated, there will be seven (7)
pairs of pins on the Squeeze & Tease 3D/WARP Board ’s
J3
connector that are not mated. This is the correct configuration.