Ross Synergy 1, Руководство по обслуживанию

Страница: 151 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16-S1) Calibration and Diagnostics • 9–9
3. Test the three knobs to the right of the display as follows:
• Press
Normal
.
• Turn each knob clockwise and counterclockwise.
The display indicates the rate at which you are turning the knob with a numeric display
and bar graph.
4. Test all other knobs as follows:
• Press
Scaled
.
• Turning the knob will display the absolute position of the knob both numerically
and graphically. The number (displayed in hexadecimal) should range from
0
(full
counter-clockwise) to
FFF
(full clockwise). The number should be stable and
jitter-free.
• If the number does not reach both limits, perform a calibration as described in the
section “
Switcher Calibration – Synergy 1 ” on page 9–2.
This completes the procedure to test the potentiometers of the Synergy 1 control panel.
Fader Test
The Fader Test Menu allows you to test the fader on the Synergy 1 control panel.
Use the following procedure to test the fader:
1. Navigate to the Panel Diagnostics Menu 1-2 as follows:
• Press HOME (to display the Main Menu 1-2 )
• MORE (to display Main Menu 2-2 )
• Setup (to display the Setup Menu )
• Panel Diagnostics (to display Panel Diagnostics Menu 1-2 )
2. Press Fader Test to display the Fader Test Menu .
Fader Test Menu
Note Contact Technical Support for details on each display value, or if a
problem with a potentiometer is suspected.