Ross Synergy 1, Руководство по обслуживанию

Страница: 117 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16-S1) Working with Installed Options • 6–9
5. Eject the storage device from the Synergy 1 switcher.
6. Label the storage device and store it in a safe place. It is recommended that you place the
following information on the label:
• Synergy 1
• Software Option Codes
• Today’s Date
• Synergy Software Version
• Serial Number
This completes the procedure for saving your option codes to a storage device.
Recalling Option Codes
In case the option codes are accidentally erased or deleted, use the following procedure to recall
option codes:
1. Navigate to the Installed Options Menu 1-2 as follows:
• Press HOME (to display the Main Menu 1-2 ).
• MORE (to display the Main Menu 2-2 ).
• Setup (to display the Setup Menu ).
• Installed Options (to display the Installed Options Menu 1-2 ).
2. Press MORE to display Installed Options Menu 2-2 .
3. Insert the storage device with the saved option codes into the Synergy 1 switcher.You
must wait 5 seconds after inserting the USB key into the USB port before you can begin
to recall your option codes.
4. Press Recall Codes From Disk to recall all of your option codes.
5. Eject the storage device from the switcher.
This completes the procedure to recall option codes.
Note
Option codes stored to storage device, such as a floppy disk or USB
key, will only work on the switcher from which they were saved.
Caution
Do NOT remove the floppy disk or USB key from the switcher before
the LED on the disk drive or USB port goes out. Doing so may destroy
the data on your floppy disk or USB key, as well as the data on the next
one you insert into the switcher.
Note
The Delete All SW Options function is reserved for factory use only.
Do not use this function.