Ross Synergy 1, Руководство по обслуживанию

Страница: 30 / 240

2–6 • System Architecture Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
Synergy 1 Frame – Rear View
The figure below illustrates the rear connector panel of the Synergy 1 frame. The connector layout is
identical for the Synergy 1 and Synergy 100 switchers.
Synergy 1 Frame — Rear View
The following section includes descriptions of each rear panel connector.
1. Fan Exhaust Vent
A grill is provided for FAN EXHAUST , behind the power supply. To prevent the frame
from overheating, do not block the exhaust vent with cables or other equipment.
2. Power Connector
One AC POWER connector is provided for frame power.
3. Power Supply LEDs
Four POWER SUPPLY LEDs are provided to indicate the condition of the power
supply (-12, +5, +10 and +15V). Under normal operating conditions, each should be lit
green.
4. Synergy Panel Port
One 8-pin shielded Telco port labeled SYNERGY PANEL is provided for
communications between the frame and the Synergy control panel.
1) Fan Exhaust Vent
2) Power Connector
3) Power Supply LEDs
4) Synergy Panel Port
5) Aux Panel Port 6) RVS 210/216 Panel Port
7) GVG 100/110 Panel Port
8) GPI I/O Port
9) Tally Ports
10) Editor Port 11) DVE Port
12) Peripheral 1 Port
13) Peripheral 2 Port
14) Output Section
15) Input Section
Important
The cable for connecting the Synergy control panel to the Synergy 1
SD frame is not wired as a standard CAT5 ethernet cable. If you need a
cable of a specific length, contact your Ross Video Representative for
ordering information.
1
Aux 8 Aux 6 Aux 4 Aux 2 PV2 PGM2
Aux 9 Aux 7 Aux 5 Aux 3 PGM1
601 REF IN
Aux 10 Aux 1 Clean PV1
2 4 6 8
3 5 7
10 12 14 16
9 11 13 15
DIGITAL PRODUCTION SWITCHER
IN
OUT
PERIPHERAL 2 PERIPHERAL 1 DVE EDITOR TALLY
2
1
GPI I/O 210/216 PANEL
100/110 PANEL
POWER
OK
-12 +5 +10 +15
SYNERGY
PANEL
AUX
PANEL
Rx
Tx
Rx
Tx
13 12 11 10 9 8 6
3 4 5 14 15
2 1 7