5. SETTING
IMR01Y36-E2
25
Continued from the previous page.
Node address setting switch MSD
Node address setting switch LSD
No.
Setting item
Data range
Factory
set value
6 Controller
communication
transmission wait time
0 to 5: 0 to 20 ms (
=
set value
×
4)
6: 30
ms
7: 50
ms
8: 70
ms
9: 100
ms
Set the standby time until the COM-JH
starts sending data after receiving data from
the controller.
0
7
Unused
Do not set this one
⎯
8
Controller address setting
0:
Controller 1 to 31: 1 to 31
1: Controller
1: 1
Controller 2 to 31: 0
2 to 8: Do not set this one
9:
Automatic acquisition of controller
address
Set the address of the controller that is
connected to COM-JH to have communication
take place with only that address.
Set “9: Automatic acquisition of controller
address” and turn on the power again to
acquire the connected controller address
automatically.
0
9
Set value initialization
0 to 8: Unused
9: Communication
environment
setting initialization execution
Initialize each communication environment
setting data item which can be set by the
rotary switch.
⎯
The number of communication data items can be calculated from the following equation.
Number of communication data items
=
(Number of words of first communication item for one module
1
+
Number of words of next communication item for one module
1
•
•
•
+
Number of words of last communication item for one module
1
)
×
Number of communication controllers
+
Fixed communication date items: 5 words
2
1
In the case of two-channel type (Z-TIO-B modules), the number of words per one module is
the same as four-channel type (Z-TIO-A modules).
2
Measured data items (IN)
Receive counter: 1 word, Alarm state: 2 words, RUN/STOP state: 2 words
Setting data items (OUT)
Setting state selection: 3 words, RUN/STOP transfer: 2 words
The number of Polling I/O communication controllers, the number of communication
measured data items (IN) and the number of communication setting data items (OUT) can
also be set via Explicit message communication, or by the configuration tool.
