Raven SmarTrax MD, Калибровка и руководство по эксплуатации

Страница: 16 / 136

C
HAPTER
3
10 SmarTrax™ MD Calibration & Operation Manual
NOTE: Refer to Error Messages section on page 100 for additional status conditions which may be displayed
in the SmarTrax on-screen widget.
INITIAL STARTUP
DATA TRANSFER
During the initial startup of the SmarTrax MD system, language data must transfer from the SmarTrax node to the
Viper 4. Allow several minutes for data transfer to complete before calibrating SmarTrax.
NOTE: The Rx and Tx diagnostic LEDs on the SmarTrax node will flash rapidly during the data transfer. The Rx
and TX lights will flash slowly or turn off when the data transfer is complete. Attempting to access the
SmartTrax MD configuration screen while language data is transferring will open a message asking
the user to try again later.
GPS CONFIGURATION
NOTE: The SmarTrax MD system will automatically attempt to detect GPS position information and will
proceed with the calibration wizard if GPS is present. If GPS messages cannot be detected, a GPS
error message will be displayed. Check any external receiver connections and verify settings in any
external GPS equipment. Contact your local Raven dealer for additional assistance if the SmarTrax MD
system still does not detect a GPS message.
INTERNAL GPS RECEIVER
NOTE: The steps below apply only to Viper 4 computers with an internal GPS receiver that is being used as
the primary GPS source.
Accept - Saves the changes made to the SmarTrax system at
the end of the setup process and returns the to the Tools
Menu.
Exit - Exits from the current screen without saving any changes
made to the system.
Display Message