Raritan CCA-0N-V5.1-E, Руководство администратора

Страница: 112 / 420

Chapter 7: Managed Powerstrips
94
Configuring Powerstrips that are Managed by Another Device in CC-SG
In CC-SG, managed powerstrips can be connected to one of the
following devices:

Dominion KX

Dominion KX2

Dominion KX2-101

Dominion SX 3.0

Dominion SX 3.1

Dominion KSX

Dominion KSX2

Paragon II/Paragon II System Controller (P2SC)

Power IQ - See Power Control of Power IQ IT Devices (on page
337)
You must know which Raritan device the managed powerstrip is
connected to physically.
Note: You can also have a Dominion PX powerstrip that is connected to
your IP network, but not connected to any other Raritan device. See
Managed PowerStrips (on page 93) for details on configuring power
control for these powerstrips.
To configure managed powerstrips in CC-SG:
1. Complete all physical connections between the device, the
powerstrip, and the nodes that are powered by the powerstrip. See
the RPC Quick Setup Guide, Dominion PX Quick Setup Guide, and
CC-SG Deployment Guide for details on physical connections
between powerstrips, devices, and nodes.
2. Add the managing device to CC-SG. The procedure varies for
different Raritan devices. See the section that corresponds to the
device the powerstrip is connected to:

Configuring PowerStrips Connected to KX, KX2, KX2-101,
KSX2, and P2SC (on page 95)

Configuring PowerStrips Connected to SX 3.0 and KSX (on
page 96)

Configuring PowerStrips Connected to SX 3.1 (on page 98).
3. Configure outlets. See Configuring Outlets on a PowerStrip (on
page 99).
4. Associate each outlet with the node that it powers. See Interfaces
for Managed Powerstrip Connections (on page 130).