PREVOST X3-45 COMMUTER, Руководство по обслуживанию

Страница: 544 / 549

SECTION 24A : LUBRICATION & SERVICING SCHEDULE
2 DOB 2490-2789 | X3-45 Commuter PA1605 Maintenance Manual (Sec 24A revised April_2019)
LUBRICATION AND SERVICING SCHEDULE
NYCT X3–45 Commuter DOB 2490-2789
Proceed to maintenance operation
every (miles)
Figure i
te
m
6 000 12 00
0
18 00
0
24 00
0
30 00
0
50 00
0
100 0
00
150 0
00
200 0
00
250 0
00
300 0
00
Lubricant / Spec.tool

1
# SECTION
1 Filled with TES389 approved fluid – change transmission fluid, Main & Lube
filters
19  I
2 Severe vocation, filled with TranSynd or TES295 synthetic fluid only, no
mixture
4
& using High–Capacity filters
5
. Transmission fluid – change every
84 000 miles
19 H
3 Severe vocation, filled with TranSynd or TES295 synthetic fluid only, no
mixture & using High–Capacity filters
. Transmission Main & Lube filters –
change every 42 000 miles
19
09 PROPELLER SHAFT
1 Perform Spicer’s Driveshaft “Inspection Procedures” 17 
2 Grease one fitting on each universal joint 17  K
10 FRONT AXLE
1 Steering knuckle (king) pins – grease two fittings per knuckle 8  K
2 Steering knuckle (king) pins – inspect 8  K
11 REAR AXLES
1 Tag axle lever pivot – grease one fitting on each pivot 18  K
2 Drive axle – check differential oil level, add if necessary 16

F
3 Drive axle – change differential oil & breather 16

F
4 Drive axle – check compact bearing axial play 16  
5 Drive axle – change grease in compact bearing (hub unit) 16 
E /

12 BRAKE & AIR SYSTEM
1 Brakes – check caliper running clearance at brake pad replacements 46
2 Brakes – check pad wear indicator. Visually check condition of the slack adjuster
cap & guide pin covers
46 
3 Air tanks – drain water from all tanks not equipped with manual drain valve

4 Haldex Consep Condenser/Separator – inspect 41 
5 Brakes – check caliper movement along guide pins, check sealing elements
(boots). Check proper functioning of the adjuster
46 
6 ABS & Electronic Stability Control systems – check proper functioning
 
7 Accessories air filter – change filter element
2 
8 Air dryer – change cartridge 12 
13 WHEELS, HUBS & TIRES
1 Hub bearing, front and tag axle – inspect
 
14 STEERING
1 Steering tie rod ends – clean & grease one fitting at each end 5

K
3
Allison Transmission recommends that customers use fluid analysis as the primary method for determining fluid change intervals. In the absence of a
fluid analysis program, the fluid change interval listed in the chart above should be used. Change filters according to chart above even if a fluid
analysis shows that the fluid doesn’t need to be changed.
4
When the transmission contains a mixture of fluids (defined as the quantity of non-TranSynd or non-TES 295 fluid remaining in the transmission after
a fluid change combined with the quantity of TranSynd or TES295 required to fill the transmission to the proper level), perform the fluid & filter change
according to the TES389 intervals.
5
Extended TranSynd or TES 295 fluid & filter change intervals are only allowed with Allison High-Capacity filters.