PREVOST X3-45 COMMUTER, Руководство по обслуживанию

Страница: 264 / 549

SECTION 11: REAR AXLES
6
DOB 2490-2789 | X3-45 Commuter PA1605 Maintenance Manual (Final Version – Rev.2 April 2016)
REF QTY
TORQUE DRY (lbf-ft)
Threads must be free of oil or other lubricant
1 12 200
2 4 120-150
3 8 405-495
1.5 DRIVE AXLE ALIGNMENT
The drive axle alignment consists in aligning the
axle according to the frame. The axle must be
perpendicular to the frame. The alignment is
achieved with the use of shims inserted between
the lower longitudinal radius rod supports and
the frame.
Drive axle alignment is factory set and is not
subject to any change, except if the vehicle has
been damaged by an accident or if there are
requirements for replacement.
If the axle has been removed for repairs or
servicing and if all the parts are reinstalled
exactly in the same place, the axle alignment is
not necessary. However, if the suspension
supports have been replaced or altered, proceed
with the following instructions to verify or adjust
the drive axle alignment.
NOTE
When drive axle alignment is modified, tag
axle alignment must be re-verified.
1.5.1 Procedure
1. Park vehicle on a level surface, then chock
front vehicle wheels.
2. Using two jacking points (which are at least
30 inches [76 cm] apart) on drive axle, raise
the vehicle sufficiently so that wheels can
turn freely at about ½ inch from ground.
Secure in this position with safety stands,
and release parking brake.
3. Install wheel mount sensors on front end
and drive axle wheels (Figure 5).
NOTE
See reference numbers on wheel mount
sensors (
Figure 6 ).
NOTE
Select axle specifications in the appropriate
chart.