Power Electronics SD 300 Series, Руководство по началу работы

Страница: 209 / 354

POWER ELECTRONICS SD300
DESCRIPTION OF PROGRAMMING PARAMETERS
207
Group 10: Second Motor → M2
This group appears if any of In.65-71 is set to 26 (second motor). In the
following table, data shaded in grey will be displayed when a related code has
been selected.
Screen Description
Default
value
Range Function
Set on
RUN
M2.4
Motor 2
acceleration
ramp
20.0s
0.0 to
600.0s
Set the acceleration ramp for second motor
adjustment. The established setting within
the parameter is the time required to reach
the maximum frequency value, starting from
0Hz.This ramp will be set according to the
process necessities.
YES
M2.5
Motor 2
deceleration
ramp
30.0s
0.0 to
600.0s
Set the deceleration ramp for second motor
adjustment. The established setting within
the parameter is the time required to reach
the maximum frequency value, starting from
0Hz.This ramp will be set according to the
process necessities.
YES
M2.6
Motor 2 rated
power
4.0Kw
0.2 kW
0.4 kW
…
30.0 kW
Set the second motor rated power according
to its nameplate.
NO
M2.7
Motor 2
frequency
60.00Hz
30.00 to
400.00H
z
Set the second motor frequency to rated
value according to its nameplate.
NO
M2.8
Control type
selection
V/Hz 0 to 4
Define the drive control type.
OPT. DESCR. FUNCTION
0 V/Hz
Scalar control mode. Drive
carries out the control
applying a voltage /
frequency ramp to the
motor.
2 Slip
Com
Slip compensation mode.
This mode reduces the
effect of motor slip.
4 S-less1 Sensorless control mode.
NO