Power Electronics SD 300 Series, Руководство по началу работы

Страница: 304 / 354

SD300 POWER ELECTRONICS
302
COMMONLY USED CONFIGURATIONS
Parameter
Default
value
Description Set value
dr.97 2.x Software version -
Cn.4 3kHz Modulation frequency 5kHz
AP.1 0
Application function
selection
2: PID control enabled.
AP.19 50.0 PID local 40.0 (adjust desired PID in %)
AP.20 0
Select PID regulator
source
0: PID set point introduced from keypad
AP.21 0
Select feedback signal
source
3: I2 input (Feedback from a signal of 0 – 20mA).
AP.22 50.0
PID controller
proportional gain
50.0
AP.23 10.0
PID controller
integration time
10.0
AP.24 0.0
PID controller
differential time
0.0
AP.28 0 PID mode
0: Process
1: Normal.
AP.29 60.00 Upper limit PID output 50.00Hz
AP.30 -60.00 Lower limit PID output 00.00Hz
AP.37 60 seg Sleep mode activation
delay
40 seg (Delay time before the drive stops).
AP.38 0.00Hz Sleep mode activation
speed
10.00Hz (Frequency to stop operating and enter
in sleep mode).
AP.39 35% Awakening level 10% (% of the feedback to start again).
In.1 50.00Hz Analog input max. freq 50.00Hz
In.52 10ms I2 filter 10ms (Analogue input current filter).
In.53 4.00mA I2 minimum current 4.00mA (I2 minimum current adjustment).
In.54 0.00 I2 minimum reference 0.00 (% of the value set In.1)
In.55 20.00mA I2 maximum current 20.00mA (I2 maximum current adjustment)
In.56 100.00 I2 maximum reference 100.00 (% of the value set In.1)
In.65 1 Digital input 1 1: Forward start command