Perkins New 1000 Series, Руководство по ремонту, Страница: 272 / 290

23
272 Workshop Manual, TPD 1350, issue 3
New 1000 Series
Twin fuelled-starting-aid
The correct procedure to remove and to fit twin fuelled
starting aids is as follows:
To remove
1 Disconnect the fuel connections and the electrical
connections.
2 Remove the starting aids.
To fit
1 Ensure that the seat faces of the manifold and the
fuelled starting aids are free of dirt.
2 Fit the nylon spacer(s) (A3) over the threads of the
starting aid. Screw the fuel starting aid into the
manifold and tighten to 31 Nm (23 lbf ft) 3,1 kgf m.
Ensure that the electrical connector(s) (A2) are in the
correct position. It is not necessary to use
POWERPART threadlock.
Caution: To prevent electrical contact when the
circuit is on and for easy removal during maintenance,
It is important that the electrical terminals face away
from the casing .
3 When the fuelled starting aids are tightened fully
into the manifold. If necessary, rotate them back, no
more than half of one complete turn, until the
electrical terminals face away from the casing.
4 Check the fuel pipes and if they are still full of fuel,
connect them to the starting aids. If the fuel has
drained from the pipes, eliminate the air from the
pipes, refer to
section 20.
5 Connect the electrical connections.
3
2
1
A
A0303
Purchased from www.WorkshopManuals.co.uk