Perkins New 1000 Series, Руководство по ремонту, Страница: 176 / 290

19
176 Workshop Manual, TPD 1350, issue 3
New 1000 Series
Flexible oil pipes
The oil cooler pipes fitted to 6 cylinder New 1000
Series engines do not have metal braid and are
separate pipes. The part number of the pipes is
stamped on a clip which is fastened to one end of
each pipe. The pipes are not interchangeable and it is
important that the correct pipes are fitted to the
engine.
To remove, to fit and to inspect 19-12
There are two arrangements (A) or (B) for the pipes
which are used in accordance with the application:
To remove
Warning! The engine oil may be hot, allow the
engine temperature to cool before the oil pipes are
released.
1 Allow the engine temperature to cool down and put
a suitable drip tray under the filter head.
2 Remove the three setscrews which retain the oil
pipes to the filter head. Release the oil pipes and
allow the oil to drain into the drip tray. Discard the
joint.
3 Remove the three setscrews which retain the oil
pipes to the oil cooler. Discard the joint.
To fit the pipes - arrangement 1:
1 Put the three setscrews into position in the flange
(A3) of the inner pipe (A5), part number 2483A005.
Put a new joint (A2) in position on the setscrews.
2 Engage the setscrews by three or four threads in
the flange of the oil cooler (A4). Engage the spigot
(A1) of the outer pipe (A9), part number 2483A006, in
the hole in the flange (A3) of the first pipe, ensure that
it fits squarely in the flange.
3 Support the pipes by hand and tighten the centre
setscrew finger tight. Tighten the other setscrews until
they are finger tight. Ensure that the pipes are as
close together as possible, then tighten the setscrews
gradually and evenly to 22 Nm (16 lbf ft) 2,2 kgf m.
4 Put a setscrew (A7) in position in the flange of the
inner pipe (A5) for the oil filter head (A10). Put a new
joint in position on the setscrew. Hold the flange and
the joint in position and fit the centre setscrew (A8).
Tighten the setscrews finger tight. Put the flange of
the outer pipe (A9) in position and fit the third
setscrew (A6), tighten it finger tight. Beginning with
the centre setscrew, tighten the three setscrews to 22
Nm (16 lbf ft) 2,2 kgf m.
4
9
6
8
1 3
2
7
10
5
A
A0304
Purchased from www.WorkshopManuals.co.uk