Perkins New 1000 Series, Руководство по ремонту, Страница: 171 / 290

Workshop Manual, TPD 1350, issue 3 171
19
New 1000 Series
To fit the idler shaft
1 Check that the new idler shaft, part number
3271H002 or 3271H004 and the hole for the idler
shaft in the bearing cap are clean and free from oil or
grease. Remove any rough edges from the hole of the
bearing cap.
2 Support the rear of the bearing cap and ensure that
the cap will not move when the idler shaft is pressed
in. Apply only enough POWERPART Retainer (oil
tolerant) around the chamfer of the shaft to fully cover
the surface of the hole when the shaft is pressed into
position. Enter the chamfer of the idler shaft into the
hole.
If the idler shaft (A3) has an oil hole ensure that the
hole (A2) in the idler shaft is at the top and that the flat
(A1) is at the bottom before the shaft is pressed into
the bearing cap.
Ensure that the idler shaft is square to the bearing cap
and press the shaft in onto its shoulder. Remove the
surplus POWERPART Retainer from the idler shaft,
the oil hole and the bearing cap before the oil pump is
fitted.
3 Use the original hole for the pin in the bearing cap
as a guide and drill a 6,35 mm (0.25 in) diameter hole
in the idler shaft 9,5 mm (0.37 in) deep.
4 Fit a new pin, part number 2116087, into the
bearing cap and idler shaft.
A
A0229
2
3
1
Purchased from www.WorkshopManuals.co.uk