Perkins New 1000 Series, Руководство по ремонту, Страница: 132 / 290

16
132 Workshop Manual, TPD 1350, issue 3
New 1000 Series
To fit a service liner
A service liner is a transition fit of +/- 0,03 mm (+/-
0.001 in) in the parent bore. A special tool will not be
necessary to fit some liners, but where a liner is a tight
fit, tool PD.150B can be used.
Caution: Do not hit a liner with a hammer.
1 Clean thoroughly the parent bore. Clean the top
50 mm (2.0 in) and the recess for the liner flange
with Loctite Safety Solvent or a similar product; use it
in accordance with the manufacturer's instructions.
2 Clean thoroughly the outer surface of the liner with
Loctite Safety Solvent.
3 Lubricate lightly the parent bore with clean engine
lubricating oil, except for the top 50 mm (2.0 in).
4 Engage the cylinder liner (A5) into the parent bore;
ensure that the liner is vertical. Put the adaptor
PD.150B-17/2 (A4) onto the top of the liner with the
shoulder of the adaptor on the liner flange. Put the
bearing (A3) into position in the recess in the top of
the adaptor with the flat face of the bearing to the
bottom of the recess.
5 Fit the threaded rod (A1) through the bearing, the
adaptor and the liner until the handle (A2) is against
the recess in the bearing. In this position adjust the
threaded rod until the end is below the bottom face of
the cylinder block.
6 Fit the adaptor PD.150B/6 (A6) onto the threaded
rod; ensure that the flat face of the adaptor is against
the bottom face of the cylinder block. Fit the washer
and the nut; ensure that the threaded rod is in the
centre of the liner and tighten the nut onto the
adaptor.
Continued
5
6
1
3
4
2
A
A0213
Purchased from www.WorkshopManuals.co.uk