2-42
Maintenance Utilities
VU-ACD™/100 Maintenance Guide – Host/DOS
2.6.1.4
InterLink Input Configuration Assignment
Step
Prompt
Action
1
InterLink INPUT CONFIGURATION ASSIGNMENT for NODE <n>
1) Node Description
InterLink Input
2) Connection Type
Serial
3) Port
/dev/ttyA13
4) Baud rate
9600
Select a parameter to modify or “q” to
quit:
Type the number corresponding to the con-
figuration parameter you wish to change and
press
Enter
.
?
Steps 2 thru 5 below describe the procedures for changing each parameter listed in the
View/Modify InterLink Configuration Assignment Menu.
2
1) Node Description
InterLink Input
Type
1
and press
Enter
to change the Node
Description.
Node Description (1 to 20 characters) [default: InterLink Input ]
Type a descriptive name for this node (up to
20 alphanumeric characters); press
Enter
to
change the Node Description.
3A
2) Connection Type Serial
Type
2
and press
Enter
to change the
connection type (Serial or LAN).
•
To change from Serial to LAN connection
proceed to Step 3B.
•
To change from LAN to Serial connection
proceed to Step 3C.
•
To quit this menu proceed to Step 4.
3B
Change InterLink Input connection type
to LAN (y/n) ?
Type
y
an d press
Enter
.
Enter the LAN Service Number for the InterLink Input
(Acceptable values are between 5000 and 65535): [ ]
Refer to the site’s master port assignment list
and type the desired Service Number; press
Enter
.
Enter the Remote Host IP address
(Example: 151.175.120.139): [ ]
Refer to the InterLink host assignment list and
type the desired IP address; press
Enter
.
Proceed to Step 4.
