Panasonic ZEQUO 6400, Руководство по эксплуатации

Страница: 688 / 1058

60. OSPFv3 Commands
689
60.16. config ospfv3
 Description
This command is used to configure an OSPFv3 interface.

Format
config ospfv3 [ipif <ipif_name 12> | all] {area <area_id> | priority <value 0-255> |
hello_interval <sec 1-65535> | dead_interval <sec 1-65535> | instance <value 0-255> |
metric <value 1-65535>| state [enable | disable] | passive [enable | disable]}

Parameters
ipif Specifies the OSPFv3 IP interface name used.
<ipif_name 12>
Enter the OSPFv3 IP interface name used here. This name can be up to 12
characters long.
all Specifies that all the OSPFv3 IP interfaces will be used.
area (Optional) Specifies a 32-bit number in the form of an IPv4 address that uniquely
identifies the OSPFv3 area in the OSPFv3 domain.
<area_id>
Enter the area ID used here.
priority (Optional) Specifies the priority used in the election of the Designated Router (DR).
<value 0-255>
Enter the priority value used here. This value must be between 0 and 255. The
default value is 1.
hello_interval
(Optional) Specifies to allow the specification of the interval between the transmission of
OSPFv3 Hello packets, in seconds. The Hello Interval and Dead Interval should be the
same for all routers on the same link.
<sec 1-65535>
Enter the hello interval value here. This value must be between 1 and 65535
seconds. The default value is 10 seconds.
dead_interval
(Optional) Specifies to allow the specification of the length of time between the receipt of
Hello packets from a neighbor router before the selected area declares that router down.
The Dead Interval must be evenly divisible by the Hello Interval.
<sec 1-65535>
Enter the dead interval value used here. This value must be between 1 and 65535
seconds. The default value is 40 seconds.
instance (Optional) Specifies the instance ID of the interface.
<value 0-255>
Enter the instance ID used here. This value must be between 0 and 255. The
default value is 0.
metric (Optional) Specifies the field that allows the entry that is the representative of the OSPFv3
cost of reaching the selected OSPFv3 interface.
<value 1-65535>
Enter the metric value used here. This value must be between 1 and 65535. The
default value is 1.