Panasonic ZEQUO 6400, Руководство по эксплуатации

Страница: 155 / 1058

12. Basic IP Commands
156
12.Basic IP Commands
In this chapter, you will configure the following basic IP network
settings for each interface.
 IP address (IPv4, IPv6), net mask, enable/disable

Proxy ARP, which responds to an ARP request to other devices

MTU (Maximum Transmission Unit) value, which specifies the maximum data size
to send (Default: 1500 bytes)
 IPv4 secondary interface
The following setting is also available.
 IPv6 Link-Local address
In general, if an IPv6 address is not configured, the link-local address is also not
configured. When the automatic configuration of link-local address is enabled, the
link-local address is automatically configured even though an IPv6 address is not
configured, allowing for communications in the local network.
 IP Setup Interface
Our free application “ZEQUO assist Plus” provides an easy-to-use user interface to
change the IP address.
config ipif <ipif_name 12> [{ipaddress <network_address> | vlan <vlan_name 32> | state [enable
| disable]} | bootp | dhcp | proxy_arp [enable | disable] {local [enable | disable]} | ipv6
[ipv6address <ipv6networkaddr> | state [enable | disable]] | ip_mtu <value 512-1712> | ipv4
state [enable | disable] | dhcpv6_client [enable | disable] | ip_directed_broadcast [enable |
disable]]
create ipif <ipif_name 12> {<network_address>} <vlan_name 32> {secondary | state [enable |
disable] | proxy_arp [enable | disable] {local [enable | disable]}}
delete ipif [<ipif_name 12> {ipv6address <ipv6networkaddr>} | all]
enable ipif [<ipif_name 12> | all]
disable ipif [<ipif_name 12> | all]
show ipif {<ipif_name 12>}
enable ipif_ipv6_link_local_auto [<ipif_name 12> | all]
disable ipif_ipv6_link_local_auto [<ipif_name 12> | all]
show ipif_ipv6_link_local_auto {<ipif_name 12>}
enable ip_setup_interface
disable ip_setup_interface
show ip_setup_interface