Panasonic ZEQUO 6400, Руководство по эксплуатации

Страница: 710 / 1058

62. Protocol Independent Multicast (PIM) Commands
711
62.8. config pim crp
 Description
This command is used to set the candidate rendezvous point (RP) related parameters.

Format
config pim crp {holdtime <value 0-255> | priority <value 0-255> | wildcard_prefix_cnt [0 |
1]}

Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

Example
To configure the candidate rendezvous point (RP) holdtime, priority and wildcard prefix
count:
holdtime(Optional) This field is used to set the time Candidate RP (CRP) advertisements are valid
on the PIM-SM enabled network. If CRP advertisements are not received by the BSR
within this time frame, the CRP is removed from the list of candidates. An entry of 0 will
send out one advertisement that states to the BSR that it should be immediately removed
from CRP status on the PIM-SM network.
<value 0-255>
Enter the hold time for the RP here. This value must be between 0 and 255. The
default value is 150 seconds.
priority (Optional) Specifies the priority used for RP election. This priority value will be included in
the router's CRP advertisements. A lower value means a higher priority, yet, if there is a
tie for the highest priority, the router having the higher IP address will become the RP.
<value 0-255>
Enter the priority value used here. This value must be between 0 and 255. The
default value is 192.
wildcard_prefix_cnt
(Optional) Specifies the Prefix Count value of the wildcard address (224.0.0.0/24) to be
choosed. The default vaule is 0.
0
Specifies that the wildcard prefix count value will be set to 0.
1 Specifies that the wildcard prefix count value will be set to 1.
Zxxx0:admin# config pim crp holdtime 150 priority 192 wildcard_prefix_cnt 0
Command: config pim crp holdtime 150 priority 192 wildcard_prefix_cnt 0
Success.
Zxxx0:admin#