Niko 550-00001, Руководство по установке

Страница: 114 / 140

18. Motor module
113
18. Motor module
Description
The motor module can operate three applications that are motor-controlled, such as roll-down shutters, curtains or sun
blinds.
Overview
550-00130
A. N screw terminals This is where the neutral conductor is
connected.
B. Screw terminals 1-3’ This is where you connect the load that
is connected to output 1 up to 3’.
C. Sliding contact The sliding contact is used for
connecting the next module, which
means that the bus and the power
supply module are then also
interconnected.
D. Buttons These buttons are used for activating or
deactivating an output. Please
remember that the activation or
deactivation is only temporary as it will
be overruled by the next bus
communication.
E. L screw terminals This is where the phase of the 230 V
mains voltage is connected. The L screw
terminals are internally linked in groups
of two.
F. ADDRESS button The function of this button is twofold. In
addition to the function described under
“D”, this button is also used while
programming the installation to send the
unique address of the module during the
addressing phase.
G. CHANNEL LEDs One LED per channel. The CHANNEL
LED lights up in TEST mode when the
output is activated.
H. STATUS LED The STATUS LED lights up in TEST mode
when the module is connected correctly
and is functioning properly. If an error
occurs, the LED will blink to indicate an
error code. See
Error codes
on page 116 .
B
D
E
G
A
C
A
A
A
H
F