Niko 550-00001, Руководство по установке

Страница: 78 / 140

11. IP interface
77
Connecting and mounting the IP interface
Follow the steps below to mount the IP interface:
1 Press the IP interface onto the DIN rail until it clicks into place. Preferably position the IP interface at the bottom of
the electrical cabinet.
2 Connect the network cable to the RJ45 port.
3 Connect the IP interface to the module before it. Slide the sliding contact of this module to the right until it clicks
into the IP interface. This will ensure that the bus and the power supply voltage are connected.
You can use the Niko Media Kit Ethernet over twisted pair to set up the IP network.
Technical data
• resting potential: 26 Vdc (SELV, safety extra-low voltage)
• dimensions: DIN 2U
• sliding contact
• RJ45 port for communication via TCP/IP
• ethernet connection speed: 10 - 100 Mbit/s
• CE marking
• ambient temperature: 0 - 45°C
• Ensure that the installation is disconnected from the mains.
• Ensure that the RJ45 port is easy to reach.
• Use a shielded network cable and keep it separate from 230 V cables to avoid crosstalk. Run the network
cable alongside the SELV cables, for instance.
• Preferably use an STP cable.
• Do not connect more than 10 Niko Home Control components to the IP interface.
• Incorporate a wireless router or wireless access point if you want to communicate with the IP interface via a
smartphone. The end-user must ensure that the WiFi network is secure.