Niko 550-00001, Руководство по установке

Страница: 89 / 140

88
13. Touchscreen
Use a drill (with a 6 mm diameter) to drill a hole of 40 mm for each plug. If you are drilling in timber, you will not need to
use the plugs, and only a drill hole of 20 mm with a 3 mm diameter will be required.
Follow the steps below to mount the touchscreen:
1 Screw the assembly plate onto the wall using the four screws and plugs supplied.
2 Connect the green screw terminal supplied to the 24V power supply cable while observing the polarity as indicated
on the back of the touchscreen.
3 Crimp an RJ45 plug onto the twisted pair cable (UTP, STP or FTP). Observe the standard colour coding for RJ45.
• Mount the assembly plate in a central position on top of the flush-mounting box.
• Make sure the assembly plate is level.
• The unevenness of walls cannot exceed 2 mm.
• If you are using PoE, you do not need a separate 24V power supply cable.
• Only use the Niko PoE supply of type IEEE802.3af. This power supply provides voltage via the free pairs.
• The green screw terminal supplied (24V power supply) is suitable for a maximum copper diameter of
maximum 1.5 mm².
Min.
1,50m