Niko 550-00001, Руководство по установке

Страница: 125 / 140

124
21. Analogue control module 0-10 V
Operation
The output will send a signal between 0 and 10 V to control the connected dimmer, which allows programmed actions or
mood settings to be activated.
By pressing the corresponding button, the status of each output can be changed manually and temporarily to connect a
light. Please remember that the activation or deactivation is only temporary as it will be overruled by the next bus
communication.
Installation
Connection diagram
Follow the steps below to install the module:
1 Press the module onto the DIN rail until it clicks into place. Preferably position the module in the top row inside the
electrical cabinet to keep the SELV cables separate from the 230 V cables.
2 Connect the dimmers to one of the screw terminals 1-3.
3 Connect the mass of the dimmers to the common screw terminal COM.
4 Connect the analogue control module 0-10 V to the module before it. Slide the sliding contact of this module to the
right until it clicks into the analogue control module 0-10 V. This will ensure that the bus and the power supply
voltage are connected.
• Ensure that the installation is disconnected from the mains.
• The distance between the dimmers and the module should not exceed 50 m.
• A maximum of three dimmers can be connected per module.
DIM
0-10 V
DIM
0-10 V
DIM
0-10 V