Hardware and Software Configuration
Appendix C
GPIB-410 User Manual
C-16
© National Instruments Corp.
Interrupt Selection
The GPIB-410 is configured to use Interrupt Request (IRQ) Line 7. One
jumper and six dual wire wrap posts are used to select the interrupt line.
The interrupt jumper array is located on the interface board with lines I2
through I7. Figure C-12 shows the factory configuration for Interrupt
Line 7. Figure C-13 shows Interrupt Lines 6 and 2.
Key:
= Used to set the DMA channels
•
•
•
•
•
•
•
•
•
•
2
3
4
5
6
7
INT
Figure C-12. Factory Default IRQ Line 7 Selected (Rev. C)
