Mitsubishi Electric MR-JE-C, Инструкция по эксплуатации

Страница: 180 / 312

8. HOW TO USE INDEXER
8 - 11
8.4 Usage
(1) idx mode operation sequence
(a) Rotation direction specifying indexer
POINT
Be sure to perform a home position return. Executing positioning operation
without home position return will trigger [AL. 90 Home position return incomplete
warning] and "Controlword bit 4 (New set-point)" will be disabled.
The servo motor rotates in a fixed direction to execute positioning to a station.
The following timing chart shows that an operation is started from being stopped at the station No. 0
at servo-on.
1) When using Profile velocity (6081h), Profile Acceleration (6083h), Profile deceleration (6084h)
For the servo motor speed, acceleration time constant and deceleration time constant during
operation, the values set in Profile velocity (6081h), Profile acceleration (6083h), and Profile
deceleration (6084h) are used.
ON
OFF
Controlword bit 6
(Operation mode)
ON
OFF
ON
OFF
Target point table (Note 1)
ON
OFF
INP/S_INP
(In-position) (Note 6)
ON
OFF
Statusword bit 12
(Set-point acknowledge)
ON
OFF
Status DO 5 bit 5
(S_CPO (Rough match))
Status DO 5 bit 6
(S_MEND (Travel completion))
ON
OFF
Point actual value
Enabled torque limit value
100.00 r/min Profile velocity
Controlword bit 4
(New set-point)
Controlword bit 5
(Direction)
Servo motor speed
(Note 4)
Forward rotation
0 r/min
Reverse rotation
(Note 3)
(Note 5)
Point demand value
1 3 1
*1
*2
*3
Torque limit value2
Positive torque limit value/
Negative torque limit value
Torque limit value2
Positive torque limit value/
Negative torque limit value
Torque limit value2
Positive torque limit value/
Negative torque limit value
Torque limit value2
(Note 5) (Note 5)
150.00 r/min
1 3 1
1 3 1
(Note 2)
Rotation direction specifying indexer operation