Mitsubishi Electric MR-JE-C, Инструкция по эксплуатации

Страница: 158 / 312

7. HOW TO USE THE POINT TABLE
7 - 29
d) Varying-speed operation by incremental value command method
Example. Operations when "10" is set in the auxiliary function of point table No. 3
Point table No.
Position data
[10 STM μm]
Servo motor
speed [r/min]
Acceleration
time constant
[ms]
Deceleration
time constant
[ms]
Dwell [ms]
Auxiliary
function
M code
1 5.00 3000.00 100 150 0 3 5
2 10.00 2000.00 150 200 0 1 10
3 5.00 1000.00 300 100 0 10 15
Operation sequence
1) Starting with point table No. 1
2) Varying the speed and executing point table No. 2
3) Varying the speed and executing point table No. 3
4) Varying the speed, and executing point table No. 1 when "10" is set to the auxiliary function
of point table No. 3
5) Repeating the above execution in the sequence of 1), 2), 3), 4), 2), 3), 4)
Target point table
Controlword bit 4
(New set-point)
ON
OFF
Point actual value (Note)
5.00
0 5.00
1)
2)
2)
3)
4)
10.00 15.00
1
5.00 5.00
M code actual value (Note)
Servo motor speed
Position address
Forward rotation
0 r/min
Reverse rotation
Acceleration time constant
(100) of point table No. 1
Acceleration time
constant (100) of
point table No. 1
Deceleration time constant
(150) of point table No. 1
Deceleration time
constant (150) of
point table No. 1
Point table No. 2
Point table No. 2
Point table No. 1
Point table No. 1
Point table No. 3
Speed
(2000.00)
Speed
(2000.00)
Speed
(3000.00)
Speed
(3000.00)
Speed (1000.00)
Note. "Point actual value" and "M code actual value" are not outputted in an automatic continuous operation.