Mitsubishi Electric MR-JE-C, Инструкция по эксплуатации

Страница: 146 / 312

7. HOW TO USE THE POINT TABLE
7 - 17
(b) Automatic continuous positioning operation
By merely selecting a point table and switching on "Controlword bit 4 (New set-point)", the operation
can be performed in accordance with the point tables having consecutive numbers.
1) Absolute value command method ([Pr. PT01] = _ _ _ 0)
By specifying the absolute value command or the incremental value command in the auxiliary
function of the point table, the automatic continuous operation can be performed.
The following shows how to set.
Point table setting
Dwell
Auxiliary function
When the position data is absolute
value
When the position data is incremental
value
1 or more 1 3
a) Positioning in a single direction
The following shows an operation example with the set values listed in the table below.
In this example, point table No. 1 and No. 3 are set to the absolute value command method,
and point table No. 2 to the incremental value command method.
Point table No.
Position data
[10
STM
μm]
Servo motor
speed [r/min]
Acceleration
time constant
[ms]
Deceleration
time constant
[ms]
Dwell [ms]
Auxiliary
function
M code
1 5.00 3000.00 100 150 100 1 5
2 5.00 2000.00 150 200 200 3 10
3 15.00 1000.00 300 100 Disabled 0 (Note) 15
Note. Be sure to set "0" or "2" to the auxiliary function of the last point table of the consecutive point tables.
0: When using the point table with the absolute value command method
2: When using the point table with the incremental value command method
Servo motor speed
Position address
Target point table
Controlword bit 4
(New set-point)
ON
OFF
Point actual value
Dwell
100 ms
Speed
(3000.00)
Acceleration/deceleration time
constant of point table No. 1
Acceleration/deceleration time
constant of point table No. 2
Speed
(2000.00)
Speed (1000.00)
Acceleration/deceleration time
constant of point table No. 3
Dwell
200 ms
5.00
0 5.00 10.00 15.00
1
1
M code actual value 05
Forward rotation
0 r/min
Reverse rotation