Mitsubishi Electric MR-JE-C, Инструкция по эксплуатации

Страница: 34 / 312

3. STARTUP
3 - 1
3. STARTUP
The items shown in the following table are the same with the contents of "MR-JE-_C Servo Amplifier
Instruction Manual". For details, refer to each section indicated in the detailed explanation field. "MR-JE-_C"
means "MR-JE-_C Servo Amplifier Instruction Manual".
Item Detailed explanation
Switching power on for the first time MR-JE-_C section 4.1
Display and operation section MR-JE-_C section 4.5
Test operation MR-JE-_C section 4.6
Test operation mode MR-JE-_C section 4.7
3.1 Startup
Connect the servo motor with a machine after confirming that the servo motor operates properly alone.
(1) Power on
When the power is switched on, "b01" (when the identification number is 01h) appears on the servo
amplifier display.
When you use the absolute position detection system, first power-on results in [AL. 25 Absolute position
erased] and the servo-on cannot be ready. [AL. 25] can be deactivated by cycling the power.
Also, if the power is switched on when the servo motor is rotated at a speed of 3000 r/min or higher, a
position mismatch may occur due to external force or the like. Power must therefore be switched on
when the servo motor is at a stop.
(2) Parameter setting
POINT
The following encoder cables are of four-wire type. When using any of these
encoder cables, set [Pr. PC04] to "1 _ _ _" to select the four-wire type. An
incorrect setting will result in [AL. 16 Encoder initial communication error 1].
MR-EKCBL30M-L
MR-EKCBL30M-H
MR-EKCBL40M-H
MR-EKCBL50M-H
(a) Selection of the positioning mode
Select a positioning mode with "control mode selection" of [Pr. PA01 Operation mode].
Control mode selection
6: Positioning mode (point table method)
8: Positioning mode (indexer method)
[Pr. PA01]