Quick start guide
rabbitone
HD1/HD2
Download full instructions from www.rabbitone.co.za
Check list
rabbitone
headphone amplifier, battery power supply and headphone stand
Pack of 8 X AA batteries
2 x RCA plugs to 2 x RCA plugs connection cable
Earth cable and lug
2,1 mm DC plug with cover boot
Polarity tester
Headphone stand assembly and connections
Assemble upright to centre of the stand by sliding over the bolt housing
Hand tighten the bolt under the stand to align the headphone arm to face forward
Insert batteries in the internal sockets, observing polarity
Two phono (RCA) cables connect to DSTV or audio device, the other two connect to the
rabbitone
Please note that if this installation is the first to be used with the source output RCA (phono output plugs), these may be corroded. Please clean
prior to usage with a scouring pad or similar ensuring a good connection. This ensures a noise free connection.
If using a audio source, connect the 3,5 mm audio jack plug or AUX cable to the side socket on the circuit board
DO NOT USE BOTH INPUTS AT THE SAME TIME
Connect headphones to the front 3,5 mm audio out socket
A earth cable is provided, connect to earth lug with wing nut and attach the end to a mains plug earth point
ON/OFF Switch
Headphone connection
Volume control
HD1 single volume control
HD2 dual volume control
Earth post, access at the rear
DC external power connection, 10 -20 VDC
2,1 mm DC plug
AUX input 3,5 mm jack
Audio input
2 X RCA phono jacks
red right, black left
Nov17
