Mitsubishi Electric GOT2000 Series, Руководство по подключению

Страница: 331 / 1224

5.4 PLC Side Setting
5 - 65
5
E
T
H
E
RNET CONNEC
T
ION
: Necessary : As necessary : Not necessary
*1 When using Q170MCPU or Q170MSCPU(-S1), set the start I/O No. to 0070H.
*2 Specify the same network No. as that of the GOT.
*3 Do not set the same station No. as that of the GOT.
*4 Set when using Ethernet module in a redundant QnPRHCPU system.
(2) Operation setting
: Necessary : As necessary : Not necessary
*1 Because port No. 5001 is fixed, these items operate at the following setting without relations to the setting given here.
• Communication date code: [Binary code]
• Initial timing: "Always wait for OPEN" (Communication is applicable while stopping the PLC CPU.)
• Enable Write at RUN time: [Enable Write at RUN time] (Writing Data is applicable while running the PLC CPU.)
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU, operate the PLC CPU ether turning OFF
and then ON or resetting.
Initial settings
(Use default value)
Open settings
Router relay parameter
Station No.<->IP information
FTP Parameters
E-mail settings
Interrupt settings
Redundant settings
*4
Routing Parameters Refer to (3)
Item Set value
Setting necessity at GOT
connection
Communication data code
*1
(Use default value)
IP address 192.168.3.19
Initial timing
*1
(Use default value)
Send frame setting
Enable Write at RUN time
*1
TCP Existence confirmation setting
Item Set value
Setting necessity at GOT
connection