Mitsubishi Electric GOT2000 Series, Руководство по подключению

Страница: 635 / 1224

11.4 PLC Side Setting
11 - 19
CC
-Link IE FIELD NETWOR
K CON
N
ECTION
11
POINT POINT POINT
Routing parameter setting of request source
Routing parameter setting is also necessary for the request source GOT.
For the setting, refer to the following.
➠
11.3.3 Routing parameter setting
■3.
GT Designer3 [Communication settings] of System configuration (Network Type: CC IE
Field)
POINT POINT POINT
[Controller Setting] of GT Designer3
For the setting method of [Controller Setting] of GT Designer3, refer to the following.
➠ 11.3.1 Setting communication interface (Controller Setting)
11.4.3 Connecting to MELSEC-Q/L series
■1.
System configuration (Network Type: CC IE Field)
*1 The CC-Link IE Field Network module is mounted on slot 0 of the base unit.
The start I/O No. of the CC-Link IE Field Network module is set at [0].
POINT POINT POINT
When connecting to Q170MCPU or Q170MSCPU(-S1)
When connected to Q170MCPU or Q170MSCPU(-S1), the start I/O No. of the CC-Link IE Field
Network communication unit is set to "70".
Item Set value
Network Type CC IE Field
Network No. 1: Network No.1
Station No. 1: Station No.1
Group No. 0 (fixed)
Mode Setting Online
Refresh Interval 25ms (Use default value)
Input for Err. Sta. Clear (Use default value)
Retry 3times (Use default value)
Timeout Time 3sec (Use default value)
Delay Time 0ms (Use default value)
Monitor Speed High (Normal) (Use default value)
<CC-Link IE Field Network module> * 1
(Use the default value for settings other than the following.)
Station No. : 0 (fixed)
Mode : Online (normal)
Network type : CC IE Field (Master station)
Network No. : 1
Total stations : 1
Network Configuration Settings :
CC-Link IE Field Network
<GOT>
(Use the default value for settings other
than the following.)
RX/RY00
H
to FFH
RW
W/
RW
r
00
H
to FFH
Network type : CC IE Field
Network No. : 1
Station No. : 1
Mode Setting : Online
Network Configuration Settings :
Monitor Speed : High
RX/RY00 to FFH
RW
W/
RW
r
00 to FFH