Mitsubishi Electric GOT2000 Series, Руководство по подключению

Страница: 798 / 1224

14 - 42
14.2 System Configuration
■12.
Connecting a sensorless servo (FREQROL-E700EX series)
Make the communication settings of the sensorless servo (FREQROL-E700EX series).
Be sure to perform the inverter reset after updating each parameter.
(1) Communication port and corresponding parameters
(2) Communication settings of sensorless servo
Set the following parameters using the PU (operation panel or parameter unit).
Do not change these parameters, even though they can be monitored from the GOT. If they are changed,
communication with the GOT is disabled.
*1 Setting items are parameter names described in the manual of sensorless servo (FREQROL-E700EX series).
*2 Settings on the GOT can be changed.
When changing the settings on the GOT, be sure to change the parameters on the inverter to correspond with the GOT settings.
*3 Sensorless servo (FREQROL-E700EX series) default values (No need to change)
GOT connection destination Parameters corresponding to inverter
PU connector
Pr.79, Pr.117 to Pr.124, Pr.340, Pr.342, Pr.549
FR-E7TR
(RS-485 terminal block)
Setting item
*1
Parameter No. Set value Contents of setting
PU communication station number Pr.117 0 to 31 ➠
14.2.9 Station number setting
PU communication speed
*2
Pr.118
192
*3
19200bps
PU communication stop bit length
*2
Pr.119 10
Data length: 7bit
Stop bit length: 1bit
PU communication parity check
*2
Pr.120 1 Odd
Number of PU communication retries Pr.121 9999
The inverter will not come to an
alarm stop.
PU communication check time interval Pr.122 9999 Communication check suspension
PU communication wait time setting Pr.123 0 0ms
PU communication CR/LF selection Pr.124
1
*3
With CR, without LF
Protocol selection Pr.549
0
*3
Mitsubishi Electric inverter protocol
Operation mode selection Pr.79
0
*3
PU operation mode
Communication startup mode selection Pr.340 1 Network operation mode.
Communication EEPROM write selection Pr.342
0
*3
Written to RAM and EEPROM