Mitsubishi Electric GOT2000 Series, Руководство по подключению, Страница: 847 / 1224

15.5 Setting on Servo Amplifier Side
15 - 25
SER
V
O
AMPLIFIER CONNECTION
15
15.5.4 Station number setting
Set each station number so that no station number overlaps.
The station number can be set without regard to the cable connection order. There is no problem even if station numbers
are not consecutive.
■1.
Direct specification
When setting the device, specify the station number of the servo amplifier of which data is to be changed.
■2.
Indirect specification
When setting the device, indirectly specify the station number of the inverter of which data is to be changed using the
16-bit GOT internal data register (GD10 to GD25).
When specifying the station No. from 100 to 115 on GT Designer3,the value of GD10 to GD25 compatible to the station
No.specification will be the station No.of the servo amplifier.
■3.
All station specification
Target station differs depending on write-in operation or read-out operation.
• For write-in operation, all station will be a target.
• For read-out operation, only one station will be a target.
Specification range
0 to 31
Specification station NO. Compatible device Setting range
100 GD10
0 to 31
For the setting other than the above, a communication timeout error will occur.
101 GD11
102 GD12
103 GD13
104 GD14
105 GD15
106 GD16
107 GD17
108 GD18
109 GD19
110 GD20
111 GD21
112 GD22
113 GD23
114 GD24
115 GD25
Station
NO.3 Station
NO.0 Station
NO.1 Station
NO.21 Station
NO. 6
Examples of station number setting
GOT