Mindray DC-80A, Руководство оператора

Страница: 53 / 391

System Preparation 3-9
3.4 Control Panel Position Adjustment
Press the control lever downwards for about 30° to rotate the control panel ±90°. Press the lever
downwards for about 60° to move the control panel upwards or downwards.
3.5 Connecting a Probe
CAUTION:
1. Press <Freeze> to freeze an image or turn off the system power
before connecting or disconnecting a probe. Failure to do so may
result in system or probe failure.
2. When connecting or disconnecting a probe, place it in the proper
position to prevent the probe from falling off or becoming damaged.
3. Hang the probe cable on the hanger located under the control panel
to avoid excessive bending and damage.
4. Only use probes provided by Mindray. Aftermarket probes may result
in damage or cause a fire.
NOTE:
If a probe port is not used for a long period of time, use the dustproof cover to protect
the probe port from dust. Failure to do so may result in bad contact.
3.5.1 Connecting a Probe
WARNING:
The probes, cables and connectors should be in proper operating
order and free from surface defects, cracks and peeling.
Otherwise, this may lead to electrical shock.
1. Keep the cable end of the transducer to the right side of the system, insert the connector into
the system port, then press in fully. (Shown in the left figure)
2. Turn the lock handle 90° clockwise to lock it securely. (Shown in the right figure)
3. Position the probe properly to avoid it being treaded on or becoming wrapped around other
devices. DO NOT allow the probe head to hang free.
Control
lever