Mindray DC-80A, Руководство оператора

Страница: 78 / 391

4-10 Exam Preparation
4.2 Select Exam Mode and Probe
CAUTION:
If the exam mode is changed during a measurement, all measurement
calipers on the image will be cleared. The general measurement data will
be lost, but application measurement data will be stored in the reports.

Selecting exam mode
1. Connect suitable probes to the system and press <Probe> on the control panel. The touch
screen displays the following dialog box:
2. Touch the screen to select the probe type and exam mode. The system exits the dialog box and
enters the selected exam mode and probe.
Click [Exit] or press <Probe> again to cancel the selection and exit the screen.
4.2.1 Dual-probe Switch
A user-defined key for dual-probe switch can be defined in preset, by which you can fast switch the
probe under B/ Color/ Power mode.
This function applies only to probes with the same exam modes.
1. Scan to obtain the image by current probe.
2. Press the user-defined key. The available probes appear on the screen.
3. Choose the probes to be compared. The system enters dual-probe mode. The image from
previous probe is frozen.
4. Scan and obtain the required image from the current probe.
5. Press the user-defined key to switch the images of two probes.
The path for setting the keys: <F10 Setup>
→[System]→[Key Settings].
1. Select the key to be defined from [Key] tab on the left side. Or, select a key from [Footswitch]
tab.
2.
Select [Image Mode]→[Dual-Probe].
3. Click [OK] to confirm the setting or exit. The setting comes into effect then.
4.3 Select the Imaging Mode
For detailed operations in each imaging mode, see chapter “5 Image Optimization”.