Mart Cyclone 30 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 87 / 322

Installation 2 - 39
Standard Turntable Power Washer v. 4.0 The MART Corporation
2. During the initial startup of your power washer the washer will fill itself to the
set-point water level. This water level is controlled by the position of the cam
on the float rod.
Moving the cam down on the float rod will raise the water level, while moving
the cam up on the float rod will lower the water level.
When the washer has completed filling to the set-point water level, the cam
and float limit switches should appear as shown in the following figure.
Fig. 2 - 17: Float Cam at SET-POINT Water Level
Turn OFF power to the washer.
Make sure the water is calm.
Remove the front reservoir cover.
Verify the water level in the machine when the cam is in relationship to the
limit switches as shown in the figure above.
Find the water-level indicator (a 3/8"-square rectangular bar) welded to the
right wall at the front of the reservoir. Refer to the following figure.