Mart Cyclone 30 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 170 / 322

Troubleshooting 6 - 9
Standard Turntable Power Washer v. 4.0 The MART Corporation
Problem: Water does not heat (steam)
Check This: Probable Cause(s)
Steam System Steam solenoid not activated
Steam source Steam not available from in-plant source
Steam trap not operating -- may be clogged
Steam-heat exchanger, hole in exchanger -- steam
escaping
Temperature controller Not set high enough to call for heat. (Increase temp)
Loose wires, (tighten).
Thermocouple (sensor) not functioning. (Replace)
Reservoir Low solution level (check float assembly & solenoid)
Float assembly Not working (clean assembly)
7-day clock Incorrect setting
Fig. 6 - 10: Troubleshooting: Water Does Not Heat (Steam)
Problem: Water does not heat (electric)
Check This: Probable Cause(s)
Electric heaters Defective element. (Replace)
Defective wires, (loose, burned)
Check for voltage
Check for proper amperage
Blown fuse. (Replace)
Temperature controller
Not set high enough to call for heat. (Increase temp)
Loose wires, Tighten
Thermocouple (sensor) not functioning. (Replace)
Reservoir Low solution level (check float assembly & solenoid)
Float assembly Not working (clean assembly)
7-day clock Incorrect setting
Fig. 6 - 11: Troubleshooting: Water Does Not Heat (Electric)
Rapid ON/OFF Cycling of heat system:
This condition is caused by the temperature sensor probe being too close to the heat
source. Position sensor probe tip to maintain a minimum of 4-6” from heat source.