Mart Cyclone 30 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 194 / 322

Options 7 - 15
Standard Turntable Power Washer v.
4
.0 The MART Corporation
2.4 Maintenance
Sludge removal is the principal maintenance required on the Clean Machine.
NOTE : You do not have to drain the washer or the oil-skimming
tank to remove accumulated sludge in the Clean Machine's sludge
holding tank.
The hydrocyclone removes contaminates larger than 50 microns (table salt is
approximately 100 microns in diameter). The exact rating is dependent on a number of
factors, including the specific gravity of the particle, the actual particle size, and the
pressure at the cyclone entrance.
The hydrocyclone expels sludge from its apex into the sludge chamber underneath.
Because the hydrocyclone also discharges some water during operation, the sludge
holding tank initially fills with water, up to the return outlet.
As operation continues, sludge that is removed from the washer displaces water in the
sludge holding tank. Clean out the sludge when it reaches the bottom of the water
return outlet.
Follow this procedure :
1. Place an approved container under the 5-inch (13 cm) cap .
2. Remove the cap from the sludge holding tank .
3. Push sludge out through the opening into the container .
4. Replace and tighten the cap .