Mart Cyclone 30 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 60 / 322

2 - 12 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v. 4.0
3. Adjust the leveling bolts so the cabinet door will stop and remain in any open
position with minimum "creeping" to a more open or closed position. Do NOT
level the machine using a bubble level on the reservoir or other part of the
machine.
Turn the leveling bolt clockwise to raise the corner of the
cabinet. Turn the leveling bolt counterclockwise to lower the
corner of the cabinet.
4. After leveling, shim under the frame of the washer, so that the washer
frame is supported by the shims, not by the leveling bolts.
WARNING! Do not shim under the leveling/anchoring feet.
This will interfere with the leveling bolts. Shim under the
frame of the washer only.
5. When the washer is level and the shims are in place, back off the tension of
the screws on the leveling bolts, so that the washer rests solidly on the
shims.
6. Re-check the door to be sure it does not "creep." If it does, repeat the
leveling and shimming procedure.
4.2. Anchoring
After you have properly placed, leveled, and shimmed the power washer, anchor it to
the floor.
Follow this procedure :
1. Use the anchor holes provided on each leveling/anchoring foot.
2. Use bolts whose diameter equals the diameter of the anchor holes.
3. Anchor the bolts solidly and completely into the floor, so that each bolt can
carry its full tensile strength. (MART recommends an epoxy-injection bolt-
anchoring system.)
4. Consult your local distributor of anchoring products for an anchoring system
that meets your requirements.