Mart Cyclone 30 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 297 / 322

- 1 -
I. GENERAL DESCRIPTION AND SAFETY PRECAUTIONS.
A. GENERAL DESCRIPTION. The Vertical Pump is designed for the industrial washer application.
The pump is flexible coupled to a constant speed motor. The pump and motor are mounted on a
structural steel baseplate. The pump end consists of a casing, shaft, impeller, backhead, suction head,
column, baseplate, discharge piping, bearing frame, and bearings. The bearing frame supports the
bearings above the solution tank, thereby preventing contamination of the bearings. Bearings are also
protected from fluid and vapors by bearing cap and lip seals.
B. PUMP IDENTIFICATION. Use the following example for identifying information about your pump
model number.
3 X 2 X 10H
C. NAMEPLATE. A nameplate is attached to each pump. The data on the nameplate should be recorded
and filed for easy reference. Nameplate data should be furnished to MART Corporation or Carver Pump
Company when ordering spare parts or requesting information. Record pump serial number and model
number on the lines below.
Pump Serial Number ___________________________________
Model Number ________________________________________
D. SAFETY PRECAUTIONS. This manual contains descriptions and instructions, which are the results of
carefully conducted engineering and research efforts. The manual is designed to provide adequate
instructions for the safe and efficient installation, operation, or maintenance of the pump. Failure or
neglect to properly install, operate, or maintain the pump may result in personal injury, property damage,
or unnecessary damage to the pump.
Observe all caution or danger tags attached to the equipment or included in this manual.
Various federal, state, and local laws and the regulations concerning OSHA affect installation,
use, and operation of pumping equipment. Compliance with such laws relating to the proper
installation and safe operation of pumping equipment is the responsibility of the equipment owner.
All necessary steps should be taken by the owner to assure compliance with such laws before
operating the equipment.
CAUTION
IMPORTANT SAFETY NOTICE
“L” means low head
“H” means high head
Nominal maximum impeller diameter
Discharge size (inches)
Suction size (inches)