Mart Cyclone 30 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 146 / 322

5 - 10 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v. 4.0
2.1.7. Wash Pump and Pump Motor (Grease)
NOTE : 10 HP wash pumps have no bearing grease points.
NOTE : Use Mobilith AW2 to grease the pump and the pump
motor.
CAUTION! Overgreasing creates heat. Do NOT overgrease
the pump or pump motor.
CAUTION! Too much lubricant is a major cause of premature
motor failure. If you apply too much grease, it is eventually
forced out of the bearing housing and begins dripping on the
motor windings. The grease then attacks and destroys the
insulation, resulting in early motor failure.
CAUTION! Use ONLY a manually operated grease gun. Do
NOT use a power grease gun.
To grease the pump, follow this procedure : (refer to the following figure)
1. Turn the main power supply OFF .
2. Remove the plugs opposite the grease fittings on both ends of the bearing
frame.
3. Clean the grease fittings .
4. Use a manually operated grease gun on the fittings.