Mart Cyclone 30 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 179 / 322

6 - 18 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v. 4.0
13. Electrical Control System
Use procedures in chapters "Installation," "Advanced Operations: Process-Control," or
"Maintenance" to correct a problem after you have diagnosed it.
Or, refer to your vendor-supplied manuals or cut sheets for instructions on correcting
problems.
CAUTION! Always turn the main power supply OFF before
working on the electrical control system.
NOTE : Use your electrical schematics to work on the electrical
control system.
NOTE : If a part or assembly on the power washer will not work,
check the "probable cause" electrical components given below.
Problem: Electrical control system
Check This: Probable Cause(s)
Overload(s) Need to be reset
Relay(s) Need to be tightened or replaced
Fuse(s) Need to be replaced
Timer(s) Need to be tightened
Need to be reset
Fig. 6 - 21: Troubleshooting: Electrical Control System
Also be sure to check:
·
Facility fuses - If defective, replace
·
Source voltage - If OFF , turn ON