Mart Cyclone 30 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 85 / 322

Installation 2 - 37
Standard Turntable Power Washer v. 4.0 The MART Corporation
6.3. Power-up Procedure
NOTE : If you need to stop the power-up procedure at any point,
press the stop button on the washer's control panel, or turn off the
main power supply .
Follow this procedure:
Preliminary Checks:
1. Is the cabinet door closed ?
2. Is the clock-override switch set OFF ?
3. Is the wash timer set to "0"?
Supply Voltage :
CAUTION : This procedure exposes personnel to dangerous
voltages and the risk of electrocution. Be sure the people
performing this task are qualified and trained for the task.
1. Verify that the electrical panel door is closed and latched.
2. Turn on the building main power supply to the Power Washer.
3. Turn electrical disconnect located on the MART Washer Control Enclosure
door to the “OFF” position.
4. Open electrical enclosure door.
3. Measure and record incoming voltage available to the washer. Perform this
test at the supply side of the main disconnect.
Water-Fill :
1. Set the temperature controller adjustment to "0." This will prevent the
burner or heating elements from activating when the washer is empty of
water, should damage to the washer have occurred in shipping. Refer to
chapter
"Advanced Operations: Process-Control" for more information.
2. Close electrical panel door.
3. Turn the electrical disconnect located on the MART Washer Control
Enclosure door to the “ON” position. If the pump/s come on, turn the
disconnect “OFF” and
immediately contact the MART Corp. for additional
instructions.
4. Turn the 7-day clock control switch to Bypass .